MODULATION WHEEL – This wheel can be used to transmit continuous controller data (CC #1 or Modulation Depth).ġ2. PITCH BEND WHEEL – Transmits MIDI Pitch Bend information to raise or lower the pitch of a note temporarily.ġ1. Transpose Up/Down – Press one of these buttons to transpose the KEYBOARD's up or down.ġ0.Non-selected zones will stay in the Octave that they were originally in. Note: Only selected Zones will change their octave position when adjusted with the Octave buttons. Octave Up/Down - Press one of these buttons to shift the KEYBOARD's octave range up or down.When the button is lit, you can use the -/+ buttons or the KEYBOARD's numeric keys to change the program number. PROGRAM – Press these buttons to change the current program (0-127). (See ADVANCED FEATURES for more information on storing presets.)Ĩ. When "RECALL" is flashing on the DISPLAY, use the -/+ buttons to select a preset. RECALL – Press these buttons to recall one of QX25's 20 available presets (01-20).
You can use these buttons to change the preset number when storing or recalling presets.ħ. DEC/INC – Decreases/increases the value shown in the DISPLAY by one. ZONE GRP – Press the TRANSPOSE Up/Down buttons together then use the TRANSPORT CONTROL buttons to activate/deactivate Zones or Groups.Ħ. ZONE RNG – Press the OCTAVE Up/Down buttons together to assign the MIDI note range of a Zone using the KEYBOARD.ĥ. See the ADVANCED FEATURES section for information on selecting and entering these assignments and values.Ĥ. when the ADVANCED button is engaged (i.e., when it is lit). ADVANCED – Press this key to access QX25's advanced or secondary functions, allowing you to assign MIDI channels, set controls, adjust velocity curves, etc. Press the Enter key to confirm your selections.ģ. The numbered keys allow you to enter values for settings. The labels above the keys indicate their functions. KEYBOARD – The KEYBOARD functions as a normal electronic piano keyboard during performance but can also be used to adjust MIDI settings and send MIDI messages.
DISPLAY – Displays the data, values, settings, etc. SUSTAIN PEDAL INPUT – Connect a 1/4" TS sustain pedal (sold separately) to this input.ġ. KEYBOARD MIDI OUT – Use a five-pin MIDI cable (sold separately) to connect this jack to the MIDI IN of an external device.ĥ.
This connection is used to send and receive MIDI data to and from your computer and may also be used to send MIDI data from your computer to a device attached to the MIDI OUT port of the QX25.Ĥ. The computer's USB port will provide power to QX25. USB PORT – Plug a standard USB cable into this outlet and into the USB port of your computer. If you are powering it via its USB CONNECTION, set the switch to "USB" when turning it on.ģ. If you are using a power adapter (sold separately), set the switch to "POWER" when turning it on.
0 kommentar(er)
